Everything you need to fully rebuild your OneUpCompositePedals.

KIT CONTAINS

• 2 CARTRIDGEOUTER BEARINGS
• 2INNER DU BEARINGS
• 2 OUTER SEALS
• 2AXLE NUTS

MAINTENANCE INSTRUCTIONS

1. Remove outer and inner end caps with 6mm hex key.

2. Remove axle nut using 9mm socket. Drive sidepedal(RHpedal) has left hand (reverse) threaded nut. Non Drive sidepedal(LHpedal) has regular right hand threaded nut.

3. Pull axle out ofpedalbody

4. Push inner bearing out with 6mm hex

5. To replace bushing use a flat head screw driver to pry against the inner surface of the bushing to pull it out. You will destroy the bushing by removing it.

6. Remove axle seal (take note of direction)

REPLACEMENT INSTALL

1. Grease new bushing and axle. Place bushing on axle and push it intopedalbody.

2. Replacepedalseal (thicker portion near flange of axle)

3. Grease and place new bearing back intopedalbody

4. Slide axle throughpedalbody and bearing

5. Replace axle nut

6. Replace both end caps